If you live in an area where wood furnaces are used (not like down here in FL where a few heat strips will do the trick), you may also be familiar with pellet furnaces. In short, pellets compressed from sawdust and wood shavings fill a hopper and are then fed into a burn pot using an electric auger system. The auger, which is basically a long screw, delivers pellets to the burn pot based on the speed dictated by the unit’s thermostat. As the burn pot ignites, the pellets burn. Heat then carries through the home via convection (air driven) means, thus allowing air flow and a blend of warm and cool air to maintain steady, even burn temperatures. A heat exchanger separates the smoke fumes from the warm air, thereby warming the room without smoking everyone out.
The lid is a big complaint from some owners. It is thin and easily warped or bent. It can’t be shut very tightly all the time, causing the smoke and the heat to escape. Not only will this affect the flavor of your food, but will also cause a higher pellet consumption. The cost of wood pellets adds up over time, it is not worth burning through bags of them just so you could pay less for a smoker. Despite this flaw, the Camp Chef SmokePro DLX can still grill and smoke your food efficiently.
I bought a Yoder YS480 three years ago. I still use my cheaper pellet grill for everyday smokes, but I use the Yoder when I want to get serious. It does a beautiful job on baby back ribs (can do up to 8 racks laying flat on the grate) and I have smoked two complete turkeys at a time. The only time I have had a problem after 2 1/2 years of smoking was caused by a failed temperature probe. I got a new probe, installed it in a few minutes, and was back up and smoking again.
Thank you so much for the kind words! I think you would be very happy with a smaller pellet grill / smoker. The wording changes depending on how you are using the device. For instance, if you are cooking at low temperatures you will get a stronger smoke profile then if you burn a pellet smoker / grill at its higher temperature range. One thing you could do for steaks is cook them at the higher range thus being able to get a sear much like you would on a direct heated Grill service, for instance on your Weber. Another option would be to cook the steak in the reverse see your method, by bringing it up to temperature at a lower smoker setting and adding some smoke flavoring that way, then removing it and bringing the smoker up to its higher settings so you can finish off the steak with some of the effect you would achieve on direct flame. I normally do this by bringing the steaks up to about 15 degrees below where I want them to finish. Then, I finish them off at the higher temperature to where they are about 5 degrees below my target. This usually means a few minutes on each side but I use a Thermapen to be sure.
Other elements of the grill are the legs, which come in varies designs and construction materials. The automatic ignition starter to start the fire as well as the digital controller where individuals can achieve up to six different cooking methods ranging from grilling to baking and smoking. With that said, one of the most important aspects that we highly recommend individuals to consider is a green with a grease bucket or an ash cleanout design that vents out all of the ash sediment from the grill.
Consumer-level Traeger grills are considered a mid-range type of pellet grill, so they’re good for those wanting to try pellet grills for the first time. Traeger models like the Lil’ Tex Elite 22 or the Tailgater cost several hundred dollars and can grill about 12 to 16 burgers at a time. Larger Traeger grills will generally carry low four-figure prices, such as the Pro Series 34 or the Select Pro, which can hold 32 to 40 burgers between the upper and lower grilling racks.
Does anyone know how to set up a pellet grill? Since pellet grills are a bit less common than a regular conventional gas grill, we had to conduct a bit of research and realized that pellet grills are as easy to set up, they just have more components. The components of the grill include a lid, which is designed to cover the contents of the grill as well as keep the heat in. Other than that, the ‘hopper’ is known as the area of the grill where an individual places the wood pellets and the grill drips the pellets onto the fire to keep the heat going.